Suprimentos e Equipamentos Elétricos

Vídeo de Demonstração do Produto

Opção de Compra e tempo de entrega

Aviso Para mais informações sobre esse produto com preço promocionais e forma de entrega, click no botão abaixo e visite o portal da loja

Ficha técnica do produto

Características	Especificações
Cutomizado	SIM
Aplicação	Utensílio do LAR
Tipo	Cabo de Extensão
Número do Modelo	Hx-fl20505ws
Nome da Marca	Frogbro
Origem	CN (origem)
Cable Type	Coaxial
Compatible Devices	Speaker
Gauge	23
Material	Copper
Flat Speaker Wire	Ghostwire
Flat Ribbon Cables	Hidden Speaker Wire
Flat Cable	Invisible Speaker Wire

Super flat wire. Can be used on the wall floor or ceiling, used for hidden speaker wires without passing through the wall.

23 gauge wire AWG 25 FT pure copper conductor. Matching 2 connectors.

Used for home theater, car audio and other low-voltage equipment connection. Less than 36V.

The paintable surface similar to white masking tape makes the thread easy to hide.

Watch our video for the complete installation guide.

The biggest problem in setting up a home theater is figuring where to run the wires. When tearing up your wall is not an option you are often left with unsightly, messy looking wiring around the edge of the room. Flat wire gives you flat neat wire runs on your floor, walls, or ceiling, giving your installation a clean, classy look without drilling any holes.

Instructions

1. Peel back and trim adhesive backing to expose about 1& of the adhesive bottom side of the Flat Wire

2. Cut around exposed conductors and remove backing.

3. Separate White Backing from the topside of the conductors in order to expose a clean copper surface. Place removed White backing on the bottom side- the adhesive side- of the conductor. (See Video)

4. Clean off any remaining adhesive on the top side of the conductor using rubbing alcohol or another solvent.

5. Trim off tips of conductors so that you have a nice clean conductor tip.

6. Slide conductors into clips on the terminal block then snap terminal block shut.

Installation Instructions

1. Clean surface VERY WELL with soap and water when possible.

2. FROGBRO as shown above. Allow a little bit extra length in case of problems.

3. Test FROGBRO with speakers to ensure that there are no problems.

4. Starting from one end, expose adhesive and apply Flat Wire, pressing firmly along center and edges of Flat Wire as you go.

5. Connect your speakers and enjoy your new setup.

White, Paintable Backing Blends in to Wall

Adhesive Backing Keeps Ghost Speaker Wire Firmly in Place

Easy Connections with Included Terminal Blocks